• ISO 9001
  • ISO 14001
  • OHSAS 18001
  • EN 1090
  • Herwaarmerken

Watersnijden

Thure Snijtechniek B.V. uses 2 water cutting machines. The largest has a cutting range of 12x3 meters and is equipped with four cutting heads. Our 2nd machine has a cutting range of 3x3 meters and has six cutting heads with these machines we are unique in Europe.

There are endless possibilities with the machines, we don't only cut mild steel, stainless steel or aluminum, but any kind of material you can imagine. Obviously, the greatest application to the cutting of flat plates, but also the cutting of tubes, profiles and rod materials is possible without any problems, this can reduce the expensive costs of any mechanical machining techniques. Also cutting in existing products is not a problem, we can align this exactly on our machine.

Advantages

  • Burr-free so no/little post-processing
  • The cut is of consistently high quality
  • No heat affected zone
  • Almost no deformation
  • Small cutting width
  • Very compact cutting plans which can save material and costs
  • Complex shapes without distortion
  • High cutting speed and very high speed productivity

materials

  • Metals: steel, stainless steel, brass, copper, titanium, aluminum etc.
  • Technical materials: rubber, insulation, foam, plexiglass, plastics etc.
  • Stony materials: marble, granite, ceramics, porcelain, plaster etc.
  • Glass : flat glass, double glass, reinforced glass etc.
  • Special materials: wood, cement, gaskets
  • Composite materials: wood glued metal, trexpa with double- bonded aluminum etc.